Most electrical fires and breakdowns in commercial buildings give warning signs long before they happen. A disciplined annual review — ideally as part of a maintenance contract — catches them early. Here is the checklist our maintenance teams use as a starting point.
- Earthing. Measure earth electrode resistance and check earth continuity to panels and equipment. Earth pits dry out and corrode over time.
- Residual current protection. Test RCCBs / ELCBs with their test buttons and, periodically, with a proper trip-time tester.
- Thermal scan of panels. A thermal camera quickly finds loose connections and overloaded breakers — the most common causes of panel fires.
- Tighten terminations. Connections loosen with thermal cycling. Re-torque busbars and cable lugs during planned shutdowns.
- Load balance. Check phase currents. Unbalanced loads overheat neutrals and waste energy.
- Cable condition. Look for damaged insulation, overcrowded trays, rodent damage and cables running hot.
- Panel housekeeping. Panel rooms are not store rooms. Keep them clean, dry, ventilated and clear of combustibles, with rubber mats and up-to-date single-line diagrams.
- Backup systems. Test DG changeover, UPS batteries and emergency lighting under load — not just at idle.
- Power factor equipment. Check APFC capacitors and contactors; failing capacitors are a common hidden cost. Learn more.
- Documentation. Make sure as-built drawings, test records and statutory certificates are current and accessible.
Warning signs that shouldn't wait for the annual check
Burning smell, warm switch plates or sockets, frequent breaker trips, flickering lights across a floor, buzzing from panels, or any shock from equipment — switch off if safe and call an electrician immediately.
Make it routine
Our annual maintenance contracts cover these checks on a schedule that suits your building, along with breakdown support. Ask us about an AMC.




